Honda Acura NSX 1991 Service Manual page 1332

Supplemental Restraint Systeemd (SRS)
CAUTION:
Always keep the short connector on the airbag
l
connector when the harness is disconnected.
Do not damage the pins of connectors.
l
No serviceable parts inside.
l
l Do not disassemble or tamper.
Do not use any SRS unit which has been sub-
l
jected to water damage or shows signs of being
dropped or improperly handled, such as dents,
cracks or deformation.
1.
Disconnect the battery negative terminal, then dis-
connect the positive terminal.
2. Remove the maintenance lid A below the airbag,
then remove the short connector.
SHORT
MAINTENANCE
LID-A
3. Disconnect the connector between the airbag and
cable reel.
4. Connect the short connector to the airbag side of
the connector.
2 3 - 3 4 8
5 . Pull down the carpeting from the front console.
FRONT CONSOLE
6. Disconnect the SRS unit connector, then unclip the
SRS main harness from the holders.
7. Remove the SRS unit mounting bolts (4).
8. Pull out the SRS unit from the passenger's side.
TORX @ BOLTS 6 mm
CABLE REEL
CONNECTOR
SRS MAIN HARNESS
CARPET
CLIP
TORX i BOLTS
6 m m