Honda Acura NSX 1991 Service Manual page 794

Problem code 3-3: The output torque signal (TO OUT).
ALB 2.3 (20A) fuse
Remove the
for more than 3 seconds to reset
TCS control unit.
Start the engine.
Is problem code 3-3
Y E S
Start the engine.
Measure the voltage between the
TCS control unit No. 39 terminal
and body ground.
Is there appproximately 3.3 V
Y E S
l Substitute a known-good TCS
control unit and recheck.
loose wires.
(To page 19-I 08)
Intermittent failure.
Check for poor connections or
loose wires.
NOTE:
the 10 V
range or a similar range in the ana-
log tester.
N O
---- High torque
12-P CONNECTOR
View from terminal side.
WIRE