Honda Acura NSX 1991 Service Manual page 849

. Installation
Scrape the old adhesive smooth with a knife, to a
1 .
thickness of about 2 mm (0.08 in.) on the bonding
surface around the entire windshield flange.
NOTE:
the body; damaged paint will interfere with pro-
per bonding.
l Remove all traces of the rubber spacer material
from the body.
2. Clean the body bonding surface with a sponge
dampened in alcohol.
NOTE: After cleaning, keep oil, grease or water
from getting on the surface.
3. If the old glass is to be reinstalled, use a putty knife
to scrape off all traces of old adhesive, then clean
the glass surface with alcohol where new adhesive
is to be applied.
NOTE: Make sure the bonding surface is kept free
of water, oil and grease.
CAUTION: Avoid setting the glass on its edges;
small chips may later develop into cracks.
Clean the shadowed
4. Glue the lower spacers and defrost panel seals in
place as shown.
LOWER SPACER
DEFROST PANEL VERlCLE
5. Set the windshield upright on the spacers, then
center it in the opening. Mark the location by mark-
ing lines across the glass and body with a grease
pencil at the four points shown.
ALIGNMENT MARKS
NUMBER