Honda Acura NSX 1991 Service Manual page 842

Doors
12. Adjust the clearance "6" as follows.
-1 Loosen the bottom glass guide locknuts and
turn the adjusting bolts until the clearance "B"
is within the specified value.
GUIDE
NOTE: Turn the front and rear adjusting bolts
the same amount so as to keep the glass guide
bracket parallel with the seating surface of the
door panel.
After tightening the adjusting bolts, make sure
that the ends of the bolts still project out of the
locknuts.
ADJUSTING
BOLT
GLASS
ADJUSTING BOLT
GLASS
GLASS GUIDE
DOOR
-2 Align the front sash and rear sash with the
glass with the adjusting bolts at the bottom of
the sashs.
REAR SASH
-3 Adjust and set the front and rear stabilizers in
the positions which will ensure correct
clearance "B", then retighten the stabilizer
bolts securely.
-4 Move the glass up and down to seat it, then
measure the clearance "B" at the designated
locations.
-5 Align the front sash and rear sash with the
glass, then tighten the attaching nut securely.
-6 Again measure the clearance "H" to make
sure it is still within the specified limit at the
designated locations.
NOTE: Repeat the above steps until the cor-
rect clearances
out
, - - -
ADJUSTING BOLT
DE
are obtained.