Honda Acura NSX 1991 Service Manual page 861

11. Scrape or wipe the excess adhesive off with a put-
ty knife or gauze.
NOTE: Use a soft shop towel dampened with
alcohol to remove adhesive from a painted surface
or glass.
12. After the adhesive is dry, spray water over the
glass and check for leaks. Mark leaking areas and
let the glass dry, then seal with sealant.
NOTE: Let the car stand for at least 4 hours after
glass installation. If the car has to be used within
the first 4 hours, it must be driven slowly.
13. Remove the spacers.
14. Install the support struts.
Rear Hatch Glass
Molding
Replacement
Remove the rear hatch (page 20-53).
1 .
2. Place the glass on its surface as shown.
CAUTION: Avoid setting the glass on its edges;
small chips may later develop into cracks.
3. With a helper holding the glass, carefully cut off the
molding.
4. Turn the glass over, then cut the outer side rubber
portion @I of the molding.