Honda Acura NSX 1991 Service Manual page 1317

2. Connect the SRS test harness D between the dash
sensor and SRS main harness 2-P connector.
Check the resistance between the No. 1 terminal and
No. 2 terminal.
SRS MAIN WIRE
2-P CONNECTOR
SRS TEST
N o . 1
HARNESS D
is faulty: replace and recheck the voltages accord-
ing to the chart on page 23-330.
If resistance is less than 5 Kg, the SW main wire
l
harness is faulty: replace the SRS main wire har-
ness and recheck the voltages according to the
chart on 'page 23-330.
Mode D: Airbag inflator or
1 . Disconnect the battery negative terminal and then
disconnect
2. Connect the SRS test harness B between the SRS
unit and SRS main harness's 18-P connector.
Measure the resistance between the B 1 and the 87
terminal.
SRS TEST
HARNESS B
No. 2
0.2 KQ
If resistance is less than 0.2 KQ, the SRS unit is
l
faulty, substitute a known good SRS unit and
recheck the voltages according to the chart on
page 23-330.
3. Disconnect the cable reel harness and main har-
ness's 6-P connector, and connect the SRS test har-
ness C only to the cable reel harness side 6-P
connector.
4. Measure the resistance between the No. 4 terminal
and the No. 5 terminal.
cable reel open.
the positive terminal.
SRS UNIT
SRS MAIN HARNESS
1 B-P CONNECTOR