Honda Acura NSX 1991 Service Manual page 1200

Side Maker/Turn Signal/Hazard Flasher System
-Hazard Switch Removal
All SRS wire harnesses and connectors
are colored yellow. Do not use electtical
on these circuits.
CAUTION: Be careful not to damage the SRS wire har-
nesses when servicing the lighting system.
1.
Remove the dashboard lower panel and disconnect
the 2-P connectors from the floor wire harness.
Disconnect the 18-P connector from floor wire
2.
harness.
3. Remove the tilt cover.
4. Remove the steering column lower cover and upper
test equipment
cover.
NOTE: Be careful not to damage steering column
L O W E R P A N E L
5.
Remove the 4 screws then remove the hazard switch
and wiper/washer switch assembly.
COVER
covers.
WIPER/WASHER
SWITCH