Honda Acura NSX 1991 Service Manual page 1093

NOTE: It is only necessary to separate the pulley, drive
end housing and rotor when the front bearing needs
replacement.
To remove the pulley and rotor, use 10 mm and 22 mm
box wrenches to loosen the pulley locknut. Use an im-
pact wrench to remove the nut if necessary.
TERMINAL INSULATOR
END COVER
\
BRUSH HOLDER
INSULATOR
B R U S H E S /
Inspection,
SPACER RING
R O T O R 1
Test, page 23-109
CAUTION! Do not get grease
or oil on the slip rings.
BRUSH HOLDER
VOLTAGE REGULATOR
I
page
23-108
DIODE (RECTIFIER) ASSY
Test, page 23-l 08
INSULATOR SLEEVE
RETAINER
FRONT BEARING
PULLEY LOCKNUT
115 N-m (I 1.5 kg-m, 83 lb-ft)
REAR HOUSING ASSY
disassemble.
Do not
Test, page 23-109
PULLEY LOCKNUT
115 N*m
kg-m, 83 lb-ft)
2 3 - 1 0 7