Honda Acura NSX 1991 Service Manual page 478

Transmission
-Removal
Make sure lifts are placed properly, and
hoist brackets are attached to correct position. (See page
l - 6 . )
CAUTION: Use fender covers to avoid damaging painted
surfaces.
Check and record the rear camber.
1 .
2. Disconnect the battery negative (- 1 first, and
positive (+ 1 cable from the battery.
Drain automatic transmission fluid (ATF).
3.
Reinstall the drain plug with a new washer.
NOTE: Removing the ATF level gauge will allow the
ATF to drain more rapidly.
N M SPEED SENSOR
CONNECTOR
STARTER MOTOR
\
CABLE
STARTER MOTOR
STARTER MOTGR
MOUNTING BOLT
SHIFT CONTROL
SOLENOID VALVE
CONNECTOR
CONNECTOR
14-96
LOCK-UP CONTROL
SOLENOID VALVE
CONNECTOR
TRANSMISSIO
HOUSING BOLT
A I
GROUND CABLE * TRANSMISSION
MOUNTING BOLT
4. Remove the strut bar.
5. Remove the air cleaner case. (See Section 11 .I
6. Remove the connectors from the control box and
remove the control box.
CAUTION: Do not remove the vacuum tubes from
the control box.
7. Remove the wire harness holder, disconnect the
speed sensor wire connectors, solenoid valve wire
connectors, starter motor cables and transmission
ground cable.
8. Remove the ATF cooler as it is connected by the
hoses.
CAUTION: Do not remove the hoses from the
cooler.
9. Remove the starter motor mounting bolts, then
remove the starter motor.
10. Remove the transmission housing bolts and the
transmission mounting
N
ATF
bolts.
CONTROL BOX
ATF COOLER
I
ATF COOLER O-RING
Replace.
I
SENSOR
CONNECTOR