Honda Acura NSX 1991 Service Manual page 877

Hood
1. Disconnect the windshield washer hose at the Y-joint, then pull it out of the hood.
2. Remove the hood by removing the 2 hood mounting bolts on each side.
3. To remove the hood hinges, remove the front windshield lower
ALIGNMENT
l
The hinges should be shimmed to adjust the height of the hood at the rear edge.
l
Adjust the hood latch to obtain the proper height at the forward edge (page 20-52).
4. Install the new hood. After installing, adjust the hood fit to the opening.
SHIM
Use shims as required to make
the hood fit flush with the
bumper at the f,ront edge. I
STRIKER MOUNTING
BOLTS
10 N-m (1.0 kg-m,
STRIKER
I
Adjust the striker right or left to
align it with the latch.
HOOD MOUNTING BOLTS
10 N-m (I .O kg-m, 7 lb-ft)
HINGE SHIM
Use shims as necessary,
to make hood flush with
body at rear edge.
molding.
HOOD HINGE