Honda Acura NSX 1991 Service Manual page 674

1.
Remove the center cap, then pry the spindle nut
lock tab away from the spindle and loosen the nut.
2. Raise the car and support it with safety stands (see
Section I).
\ \
SPINDLE NUT
After tightening, use a drift
to stake spindle nut shoulder
against the driveshaft.
3. Remove the rear wheels.
NOTE: Before installing the wheel, clean the
mating surfaces of the brake disc and inside of the
wheel.
4. Remove the spindle nut.
5. Remove the speed sensor from the knuckle and
rear lower control arm, but do not disconnect it.
NOTE: Be careful when installing the sensors to
avoid twisting wires.
SPEED'SENSOR
a Corrosion resistant bolt/nut
WHEEL NUT
110 Nom
BANJO BOLT
35 N*m
(3.5 kg-m, 25 lb-ft)
7.
110 Nom
(11 kg-m, 80 lb-ft)
Remove the banjo bolt and disconnect the brake
hose, then remove the brake hose clamp from the
knuckle.
CAUTION: Avoid spilling brake
plastic or rubber surfaces as it can damage the
finish;
Wash spilled brake fluid off immediately with clean
w a t e r .
Remove the rear caliper by removing the mounting
bolts.
CALIPER
,
fluid on painted,
BRAKE HOSE
10 N-m
ASSEMBLY
18-31