Honda Acura NSX 1991 Service Manual page 871

SRS wire harnesses are routed near the dashboard and
steering column.
All SRS wire harnesses and connec-
tors are colored Yellow. Do not use electrical test
equipment on these circuits.
CAUTION: Be careful not to damage the SRS wire
harnesses when servicing the dashboard and steer-
ing column.
L. DASH
SENSOR
HARNESS
1 . To remove the dashboard, first remove the:
(page 20-43).
To avoid accidental deployment and
possible injury always install the protective short
connector on the inflator connector when the
harness is disconnected.
2. Lower the steering column (See Section 17).
NOTE: To prevent damage to the steering column,
wrap with a shop towel.
R. DASH
SENSOR
3. Remove
Remove the gauge assembly.
GAI
5. Remove the attaching screws, then remove the
side air vents from each side of the dashboard.
SIDE AIR VEN
the instrument panel.
INSTRUMENT
PANEL
23
17 lb-ft)
DASHBOARD