Honda Acura NSX 1991 Service Manual page 1185

Trunk Light Test/Replacement -
NOTE: The bulb or lens alone can be replaced without
having to remove the trunk side trim panel.
1 . Remove the trunk side trim panel.
Disconnect the 3-P connector from the housing.
2.
Remove the 2 screws and the retainer plate to re-
3.
move the light from the trunk side trim panel.
Make sure that the bulb is in good condition.
4 .
Check for continuity between the terminals.
NOTE: Do not connect the tester probes in the
wrong polarity because there is a diode inside the
trunk light.
TRUNK SIDE
PANEL
From
To GROiND(G501)
Latch Switch Test/Replacement -
1 .
2.
3.
LOCK ROD
RETAINER
4.
5.
Open the trunk lid and remove the trunk rear trim
panel.
Disconnect the 3-P connector from the trunk latch.
There should be continuity between the A terminal
and body ground. Theree should be continuity when
the latch is open position.
TRUNKLATCH
3-P CONNECTOR
If necessary, disconnect the lock rod from the latch,
then remove the 2 bolts to pull out the latch from
the trunk rear panel.
Disconnect the trunk opener cable from the latch.
23-199