Honda Acura NSX 1991 Service Manual page 1064

I
Starting System
NOTE: The air temperature must be between 15 and
Recommended Procedure:
Use a starter system tester.
Connect and operate the equipment in accordance
with manufacturer's instrucions.
Test and trobleshoot as described.
Alternate Procedure:
Use the following equipment:
l
l Hook up voltmeter and ammeter as shown.
NEGATIVE
23-78
CABLE
Disconnect the No. 13 (3OA)
box.
2. Check the starter engagement:
Press the clutch pedal all the way (M/T only), and
turn the ignition switch to "Start." The starter
should crank the engine.
NOTE: On cars equipped with manual transmission,
the engine will not crank unless the clutch pedal is
fully depressed.
If the starter still does not crank the engine, check
l
the battery, battery positive cable, ground and the
wire connections for looseness or corrosion.
If the starter still does not crank the engine,
bypass the ignition switch circuit as follows:
Unplug the connector (BLKNVHT wire) from the
starter. Connect a jumper wire from the battery
positive f + 1 terminal to the solenoid terminal. The
starter should crank the engine.
U
fuse from the main fuse
FUSE
SOLENOID TERMINAL
WIRE