Honda Acura NSX 1991 Service Manual page 657

Wheel Alignment
NOTE:
ment designed specifically for four wheel indepen-
dent suspensions and capable of immediate
feedback.
1 . Drive the car on the alignment rack.
2. Check the tire pressure and ride height as described
on page 18-6.
3. Center the steering wheel.
T o e
the right and left toe control arms.
Standard: 40 mm
Difference between right and left: 1 mm max.
-2. If the measurement is out of the specification,
loosen the locknut and adjust properly.
Loosen the nuts
40 Nom
(4.0 kg-m, 29 lb-ft)
Camber
arm adjusting point and adjust the cam posi-
tion so that the right and left graduations on
the adjusting cam are in contact.
-2. Mark the arm in the position which aligns with
the dial center of the adjusting cam.
Graduation in contact
with groove wall
\ GROOVE WALL
DIAL \
Graduation in
contact with
groove wall
4. Measure the readings for camber and toe according
to the alignment equipment
instructions.
5. Adjust the camber and toe at the same time on one
side of the car. Repeat for the other side of the car.
Rear Specifications
T o e
Camber -1 degrees 30' k 30'
Loosen the nut
125 N-m
(12.5 kg-m, 90 lb-ftl
manufacture's