Honda Acura NSX 1991 Service Manual page 1236

Power Door Mirrors
1 . Remove the door trim panel and carefully remove the
plastic cover (see section 20).
2. Disconnect the power mirror 3-P connector.
3. Test actuator operation:
Connect battery positive to the
TILT UP:
No. 3 terminal and negative to the
No. 2 terminal.
Connect battery positive to the
TILT DOWN:
No. 2 terminal and negative to the
No. 3 terminal.
SWING LEFT: Connect battery positive to the
No. 2 terminal and negative to the
No. 1 terminal.
SWING RIGHT: Connect battery positive to the No.
1 terminal and negative to the No.
2 terminal.
4. If the mirror fails to operate properly, replace it.
23-2 52
View from wire side
1 . Remove the door trim panel and carefully remove the
plastic cover (see section 20).
2. Disconnect the power mirror 3-P connector.
3. Remove the 2 mounting nuts while holding the
mirror.
DOOR NilRROR
POWER MIRROR C
NUTS