Honda Acura NSX 1991 Service Manual page 337

6.. Install the release bearing on the pressure plate.
7. Install the pressure plate.
NOTE:
the pressure plate.
come off.
Align the marks.
Place the diaphragm spring fingers
in the groove of the release bearing.
6. Torque the bolts in a crisscross pattern as shown.
Tighten them two turns at a time to prevent warp-
ing the diaphragm spring.
NOTE: Place the diaphragm spring fingers in the
groove of the release bearing.
9. Remove the alignment tool and ring gear holder.
10. Initialize the mid plate guides (See Page 12- 16).