Honda Acura NSX 1991 Service Manual page 859

2. Install the rear hatch frame and adjust it fit to the
rear window weather strip and engine cover seal.
NOTE: Do not install the support struts.
3. Glue the outer and inner rubber dams to the inside
face of the glass as shown to contain the adhesive
during installation.
NOTE:
glueing surface with the printed dots.
l
Be careful not to touch the glass where adhesive
will be applied.
primer.
REAR HATCH FRAME
4. Place the glass gently on the rear hatch frame, then
center it in the opening. Mark the location by mark-
ing lines across the glass and body with a grease
pencil at the four points shown.
NOTE: Put several spacers between glass and
rear hatch air scoop to prevent glass from sliding
down.
ALIGNMENT MARKS
5. With a brush, apply a light coat of glass primer of
the glass as shown, then lightly wipe it off with
gauze or cheesecloth.
NOTE:
not get body and glass primer brush mixed up.
hands. If you do, the adhesive may not bond to
the glass properly, causing a leak after the glass
is installed.
from the primed surface.
mm (0.3 in)
8
4 - L
: fipply glass primer here.
2 0 - 3 3