Honda Acura NSX 1991 Service Manual page 1114

Gauge Assembly
CAUTION:
All SRS electrical wiring harnesses are covered with
l
yellow outer insulaton.
l Replace the entire affected SRS harness assembly
if there is an open circuit or damage to the wiring.
After installation of the gauge assembly, recheck the
l
operation of the SRS Indicator light.
A-CONNECTOR (Carries in the SRS indicator signal)
.
AIN WIRE HARNESS
1 . Remove the dashboard lower panel and disconnect
the two connectors from the floor wire harness.
2 CON6ECTORS
FOOT WHEEL LIGHT
LOWER
PANEL
\
LIGHTS-ON CHIME
2 . Remove the 2 screws, then remove the dashboard
center panel from the dashboard.
3. Disconnect the TCS switch and the retractor switch
connectors.
4. Remove the 6 screws, then remove the instrument
panel from the dashboard.
INSTRUMENT
DASHBOARD
CENTER
PANEL
PANEL