Honda Acura NSX 1991 Service Manual page 848

Windshield
Removal
CAUTION:
T remove the windshield, first remove the:
1. O
l Seats (page 20-38).
l Rearview mirror (page 20-41).
l
Front pillar retainer (page 20-20).
l
Front wiper and air scoop (See Section 23).
l
Front pillar trim and headliner (page 20-37).
Peel off the upper molding.
2.
Apply protective tape along the edge of the
3.
dashboard and body next to the glass as shown.
UPPER
MOLDING
FASTENER
Replace.
UPPER
MOLDING
Replace.
Replace.
4. Using an awl, make a hole thrugh the windshield
adhesive from inside the car. Push piano wire
through the hole and wrap each end around a piece
DAM
5. With a helper on the outside, pull the wire back and
forth in a sawing motion and carefully cut through
the adhesive around the entire windshield.
CAUTION:
l
Hold the piano wire as close to the glass as
possible to prevent damage to the body and
dashboard.
l
Take care not to damage the vehicle identifica-
tion number plate.
LOWER
SPACERS
6. Cut the lower spacers and upper fastener away
from the body with a knife; they are cemented in
place.
NOTE: Replace the rubber spacers with new ones
whenever the windshield has been removed.
\
IDENTIFICATION
PLATE