Honda Acura NSX 1991 Service Manual page 850

Windshield
-Installation (cont'd)
Glue the rubber dam to the inside face of the wind-
shield as shown to contain the adhesive during
installation.
NOTE: Be careful not to touch the glass where
adhesive will be applied.
7. With a sponge, apply a light coat of glass primer
around the edge of the glass as shown, then lightly
wipe it off with gauze or cheesecloth.
NOTE:
not get body and glass primer sponges mixed
hands. If you do, the adhesive may not bond to
the glass properly, causing a leak after the wind-
shield is installed.
from the primed surface.
2 0 - 2 4
10 mm (0.4 in.)
2 m m
8. Thoroughly mix all the adhesive and hardener
together on a glass or metal plate with a putty
knife.
NOTE:
mixing.
l
Follow the instructions that come with the
adhesive.
9. Before filling a cartridge, cut off the end of the noz-
zle at the angle shown.
Cut off nozzle end
as shown.
10. Pack adhesive into the cartridge without air
pockets to ensure continuous delivery. Put the car-
tridge in a caulking gun and run a bead of adhesive
around the edge of the glass as shown.
NOTE: Apply the adhesive within 30 minutes after
applying the glass primer.
Make a sliahtlv thicker
bead at each dorner.
10 mm (0.4 in.)
7
mm (0.28 in.)
2 m m
in)
1 3 m m
: ADHESIVE
(0.5
in)
W
8
mm (0.3 inl
in.)