Honda Acura NSX 1991 Service Manual page 880

Trunk Lid
Remove the 7 attaching screws, then remove the rear hatch air scoop.
1.
2 . Disconnect the high-mount stop light harness connector and remove the harness clamp from the support strut.
3. Remove the trunk lid by removing the 4 mounting bolts.
4 . Assemble in the reverse order.
NOTE: Before tightening the bolts, check the adjustments shown below.
TRUNK LID MOUNTING
BOLTS
10 Nom (I .O kg-m,
7 lb-ft)
SUPPORT STRUT
SUPPORT STRUT
BOLT
-
SHIM
Use shims as required to make
the trunk lid fit flush with the
body at the rear edge.
STRIKER
Adjust the strike right or left to
align it with the latch.
2 0 - 5 4
HINGE MOUNTING
BOLTS
10 N-m (1.0 kg-m,
7 lb-ft)
HIGH-MOUNT
LIGHT HARNESS
TRUNK LIi3 HINGE
Adjust the hinges fore and aft,
and right and left as necessary
to equalize the gap between the
trunk lid and the body.
STOP LIGHT
HARNESS
- -
kg-m, \
STOP
, / _
TRUNK LID EDGE
CUSHIONS
Turn as necessary, to
make the trunk lid fit
flush with the body.
REAR HATCH
AIR SCOOP