Honda Acura NSX 1991 Service Manual page 556

Driveshafts
6. Remove the speed sensor from the knuckle and
rear lower arm, but do not disconnect it.
NOTE: Avoid twisting the wires when reinstalling
the sensors.
a 23
7. Remove the cotter pin from the toe control arm
castle nut and remove the nut.
8. Install the 10 mm hex nut on the ball joint. Be sure
that the 10 mm hex nut is flush with the ball joint
pin end, or the threaded section of the ball joint pin
might be damaged by the ball. joint remover.
9. Position the special tool between the knuckle and
control arm as shown, then separate the toe con-
trol arm.
CAUTION: Be careful not to damage the ball-joint
boot.
COTTER PIN
Replace.
On reassembly,
bend
TOE CONTROL AkM
16-4
*Corrosion resistant bolt/nut
10
x mm CASTLE NUT
1.25
44 N-m
(4.4 kg-m, 32 lb-ftl
10. Hold the stabilizer link with a wrench and remove
the damper mounting nut.
DAMPER MOUNTING
NUT
Replace.
95 Nom
(9.5 kg-m,
67 lb-ft)
*Corrosion resistant bolt/nut
11. Remove the stabilizer link from the stabilizer bar
and knuckle.
STABILIZER y
LINK *Corrosion resistant bolt/nut
REAR
DAMPER
* 1 2 x 1.25mm
SELF-LOCKING NUT
(8.5 kg-m, 61 lb-ft)