Honda Acura NSX 1991 Service Manual page 672

Rear Suspension
Torque Specifications
CAUTION:
l
Replace the self-locking bolts if you can easily thread a non-self-locking nut past their nylon locking inserts.
(It should require 1 Nom (0.1 kg-m, 0.7 lb-ft) of torque to turn the test nut on the bolt).
The vehicle should be on the ground before any bolts or nuts connected to rubber mounts or bushings are tightened.
NOTE: Wipe off the grease before tightening the nut at the ball joint.
*Corrosion resistant bolt/nut
a SELF-LOCKING NUT
1 0 x 1.25mm
Replace
54 Nom (5.4 kg-m, 39 lb-ft)
*SELF-LOCKING
1 4 x 1.5mm
Replace.
125 N-m
(12.5 kg-m, 90 lb-ft)
10 x 1.25
60 N-m
(6.0 kg-m. 43 lb-ft)
*FLANGE BOLT
12 x 1.25 mm
85 Nom
(8.5 kg-m, 62 lb-ft)
NUT
(9.5 kg-m, 69 lb-ft)
MOUNTING BOLT
110 N-m
(11 kg-m, 60 lb-ft)
\
NUT
1 4 x 1.5mm
Replace.
125 N-m
(12.5 kg-m, 90 lb-ft)
95 Nom (9.5 kg-m,
69 lb-ft)
I
2 6 x 1.5mm
335 Nom (33.5 kg-m, 242 lb-ft)
NOTE: After tighten-
ing, use a drift to
stake the spindle nut
shoulder against the
d r i v e s h a f t .
\
12 x 1.25 mm
Replace.
95 N-m
(9.5 kg-m, 69 lb-W
10 x 1.25 mm
44 N-m (4.4 kg-m,
32 lb-ft)
N U T
12 x 1.25 mm
60 N-m
(6.0 kg-m, 43 lb-ft)
NUT
18-29