Safety Indicator
All SRS wire harnesses and connectors
are colored yellow. Do not use electrical test equipment
on these circuits.
CAUTION: Be careful not to damage the SRS wire har-
nesses when servicing the safety indicator system.
Remove the dashboard lower panel, center panel and in-
strument panel. Disconnect the B-connector (30-P) from
the
gauge
assembly.
(See page 23-128)
Make the following input tests at the harness pins. If all
tests prove OK, yet the indicator still fails to work, replace
the
safety
indicator.
23-148
B-CONNECTOR
View from terminal side
YEL
A-CONNECTOR