Honda Acura NSX 1991 Service Manual page 592

7. Remove the set screw locknut using the special tool.
mm,
50 LOCKNUT WRENCH
8. Remove the set screw using the special tool.
Check the dust seal for damage and remove it if
l
it must be replaced. Refer to page 17-25 for in-
stallation.
DUST SEAL
SET SCREW
PINION SCiEW WRENCH
9. Move the rack toward the gearbox side (i.e. in the
direction of the arrow) as far as it goes, and out
pinion assembly pull when the pinion gear contacts
the cutout in the rack.
NOTE: The rack cannot be removed from the rack-
end side.
Arrow direction.
bearing outer race as shown.
NOTE: This type of the bearing has play. The play
should not be excessive.
UPPER-
BEARING
OUTER RACE
the
STEERING
PINION
BALL