Honda Acura NSX 1991 Service Manual page 675

Rear Suspension
Hub Replacement (cont'd)
8. Remove the 6 mm brake disc retaining screws.
'Screw two 8 x 12 mm bolts into the disc to push it
away from the hub.
NOTE: Turn each bolt two turns at a time to pre-
vent cocking disc excessively.
BRAKE DISC
9. Remove the hub unit from the knuckle.
10 x 1.25 mm
Replace.
65 Nom
bolt/nut
18-32
Rear
1 .
10 N-m
HUB DlSlASSEMBLY
bolt
2.
Wheels Bearing Replacement:
Separate the wheel bearing from the hub using the
special tools and a hydraulic press.
CAUTION:
pressed clear.
Hydraulic press
Remove the outboard bearing inner race from the
hub using the a commercially available bearing
puller.
CAUTION: To prevent damage to the tool make
sure the threads are fully engaged before pressing.
NOTE: Wash the bearing and hub thoroughly in
high flash point solvent before reassembly.
EEL BEARING
HUB DlSlASSEMBLY
INNER RACE
Replace.