Honda Acura NSX 1991 Service Manual page 857

9. Press the moldings into position around the entire
edge of the glass.
NOTE: Check that the moldings are not wrinkled
or lifted away at the corners.
UPPER MOLDING
10. Scrape or wipe the excess adhesive off with a put-
ty knife or gauge.
NOTE: Use a soft shop towel dampened with
alcohol to remove adhesive from a painted surface,
upper seal, lower fastener or glass.
11. After the adhesive is dry, install the rear defogger
sub-harness and ground cable/antenna lead in the
upper molding.
Right Side:
Ground cable/
Antenna lead
MOLDING
LOWER
MOLDING
Left Side:
Rear defogger
sub-harness
20-3 1