Honda Acura NSX 1991 Service Manual page 472

Pressure
While testing, be careful of the rotating rear wheels.
l
Make sure lifts are placed properly.
l
CAUTION:
l Before testing, be sure the transmission fluid is filled
to the proper level.
Warm up the engine before testing.
l
1 . Raise the car. (See page l-6.)
Warm up the engine, then stop the engine and
2.
connect a tachometer.
Connect the oil pressure gauge to each inspection
3.
hole(s).
18 N-m (1.8 kg-m, 12 lb-ft)
CAUTION: Connect the oil pressure gauge
securely, being sure not to allow dust and other
foreign particles to enter the inspection hole.
A/T OIL PRESSURE GAUGE SET
0 7 4 0 6 - 0 0 2 0 0 0 3
A/T OIL PRESSURE GAUGE REPLACEMENT HOSE
0 7 4 0 6 - 0 0 2 0 2 0 1
Start the engine and measure the respective pressure
4 .
as follows.
Line Pressure/Clutch
Throttle B Pressure
l
Install a new washer and the sealing bolt in the
5.
inspection hole and tighten to the specified torque.
18 N-m (I .8 kg-m, 12 lb-ft)
NOTE: Do not reuse old aluminum washers.
,
Pressure
Line Pressure/Clutch Pressure
l
-1. Allow the rear wheels to rotate freely.
-2. Run the engine at 2,000 rpm.
-3. Shift the select lever as shown on the chart on
the next page.
-4. Measure each clutch pressure.
While testing, be careful of the rotating
rear wheels.
Measurement