Inspection - Honda Acura NSX 1991 Service Manual

Countershaft
-Disassembly
5. Support 2nd gear on steel blocks as shown and
press the shaft out of 3rd and 2nd gears.
13-32
Assembly
3rd GEAR
2nd GEAR

-Inspection

1 . Inspect the gear surfaces and bearing surfaces for
wear or damage, then measure the countershaft at
points A and B.
Standard:
A (Needle bearing surface): 43.974-43.990 mm
Service Limit:
A: 43.92 mm (1.7291 in)
B: 33.93 mm (1.3358 in)
NOTE: Inspect oil passages for clogging.
Inspect for we& and damage.
If any part of the countershaft is less than the ser-
vice limit, replace it with a new one.
2. Inspect for runout.
Standard: 0.02 mm (0.0008 in) min.
Service Limit: 0.05 mm (0.0020 in)
NOTE: Support the countershaft at both ends as
shown.
Rotate two complete revolutions.
If the runout exceeds the service limit, replace the
countershaft with a new one.
11.7313-1.7319 in)
33.984-34.000 mm