Honda Acura NSX 1991 Service Manual page 671

1 . Install the damper unit, damper spring, bump stop,
bump stop plate, dust cover, dust cover end, dust
cover plate, spring mounting rubber, damper
bushings, and collar on the spring compressor.
2. Install the damper mounting base on the damper
unit as shown.
<Upper
Front
RIGHT
Mounting
bolt
direction
3. Compress the damper spring.
4. Install the damper mount washer and a new self-
locking nut 10 mm.
5. Hold the damper shaft and tighten the 10 mm self-
locking nut.
30
view>
LEFT
Bracket
position
Mounting bolt
I direction
AVAILABLE
1.
Reposition the damper on the frame with the weld-
ed nut of the. hose bracket facing outside as
shown.
MOUNTING BOLT
*Corrosion resistant bolt/nut
2. install the damper end on the lower arm and loosely
tighten the mounting nut.
NOTE: The bolts and nuts should be tightened
with the vehicle's weight on the damper.
3.
Secure the damper mounting bolt using a new self-
locking nut.
4. Secure the damper assembly to the frame with the
new three self-locking nuts.
5.
Install the caps in the top of the cowl.
CAP
Install the brake hose clamps with the two bolts.
6.
lb-ft)
(9.5 kg-m, 89 lb-ft)