Honda Acura NSX 1991 Service Manual page 856

Rear Window Molding
1. Remove the rear window and wire harness. (page
2. Place the glass on its surface as shown.
CAUTION: Avoid setting the glass on its edges;
small chips may later develop into cracks.
3. With a helper holding the glass, carefully cut off the
upper and lower moldings.
i
ADHESIVE
4. Scrape all traces of old adhesive from the
chamfered edges of the glass.
NOTE: Be sure to scrape all traces of old adhesive
thoroughly.
20-30
NOTE: Be careful not to
cut the adhesive and dam
between the inner and
outer glass.
INNER GLASS
OUTER GLASS
'ADHESIVE
5. Clean the glass surface with alcohol where the new
moldings are to be installed.
NOTE: Make sure the surface is kept free of water,
oil and grease.
6. With a brush, apply a light coat of glass primer
around the edge of the glass.
NOTE: Scrape off excess glass primer with a putty
knife after installing the new moldings.
OUTER GLASS
INNER GLASS
: Apply primer here.
7. Degrease the inner surfaces of the new moldings
thoroughly, then apply a light coat of glass primer
to the surfaces.
NOTE:
the new molding.
8. Run a bead of adhesive in the molding grooves.
EXCESS PRIMER