Honda Acura NSX 1991 Service Manual page 480

Transmission
19. Remove the intermediate shaft heat cover and the intermediate shaft mounting bolts.
20. Pry the intermediate shaft out of the differenctial.
NOTE:
Tie plastic bags over the driveshaft ends.
l
INTERMEDIATE SHAFT
SET RING
INTERMEDIATE SHAFT ---IIS
31. Remove the parking brake cable holder and the anti-lock brake system sensor wire clamp.
32. Make a reference mark on the flange of the adjusting bolt, adjusting cam and lower control arm.
33. Remove the castle nut and separate the control arm from the knuckle (See Section 18).
34. Remove the damper fork bolt.
35. Remove the bolts and lower arm from the side beam.
36. Pry the driveshaft out of the differential. Pull and remove it.
NOTE:
Tie plastic bags over the driveshaft ends.
l
DAMPER FORK BOLT -&fl
LOWER CONTRbL
ARM
14-98
Pull and remove it.
ADJUSTING
BOLT
ADJUSTING CAM
INTERMEDIATE SHAFT
'HEAT COVER
B E A M
IDE