Honda Acura NSX 1991 Service Manual page 860

Rear Hatch Glass
With a brush, apply a light coat of body primer to
6.
the original adhesive remaining around the rear
hatch frame.
NOTE:
and grease.
careful not to mix up glass and body primer
brush.
hands.
7. Thoroughly mix the adhesive and hardener
together on a glass or metal plate.
NOTE:
mixing.
adhesive.
Before filling a cartridge, cut off the end of the noz-
8.
zle at the angle shown.
Cut off nozzle end
shown.
as
20-34
: Apply body primer here.
4 mm (0.75 in.)
9. Pack adhesive into the cartridge without air
pockets to ensure continuous delivery. Put the car-
tridge in a caulking gun and run a bead of adhesive
around the edge of the glass as shown.
4 m m
(0.15 in.)
12 mm
(0.5 in.)
10. Use suction cups to hold the glass over the open-
ing, align it with the marks made in step 4 and set it
down on the adhesive. Lightly push on the glass
until its edges are fully seated on the adhesive all
the way around.
NOTE: Do not open or close the doors until the
adhesive is dry.
ALIGNMENT MARKS