Avaya DECT R4 Installation And Administration Manual page 98

Installing and operating the IPBS and IPBL
6. In the Mode drop-down list, change the DHCP mode from automatic to disabled. See
Setting DHCP mode
In a network with a DHCP Server
The MAC address for the IPBS can be found on the label on the box and on the label on the
backside. The mac number for the IPBL can be found on a label on the box.The hexadecimal
numbers (xx-xx-xx-xx-xx-xx) represent the MAC address.
Note:
Use LAN1 port for the IPBL.
Note:
Note:
To determine the IP address using this method, you must have a PC with MS
Note:
Windows. You must connect the PC to the same network domain as the IPBS/
IPBL.
To determine the IP address if the network has a DHCP server.
Note:
If you have used the IPBS/IPBL before, you must restore the IPBS/IPBL to factory
Note:
default settings by performing a long hardware reset. See
button
1. Open a command window on the PC and enter the following commands:
C:\>nbtstat -R
●
For IPBS1: C:\>nbtstat -a ipbs-xx-xx-xx
●
For IPBS2: C:\>nbtstat -a ipbs2-xx-xx-xx
●
For IPBL: C:\>nbtstat -a ipbl-xx-xx-xx
●
Where xx-xx-xx should be replaced with the last 6 hexadecimal digits of the MAC-address.
Replace xx-xx-xx with the last 6 hexadecimal digits of the MAC-address.In case of IPBL, enter
"ipbl-xx-xx-xx".
With IPBS2 use the command: C:\ nbstat -a ipbs2-xx-xx-xx
The command window displays the IP address. See the white frame in
98
Avaya DECT R4 - Installation and Maintenance Guide
on page 140.
on page 191. Then remove the power supply cable and connect it again.
Reset using the reset
figure 31.
02/2016