Advanced Charger - Avaya DECT R4 Installation And Administration Manual

Advanced Charger

For general LED indications, see also
Status LED on the charger is not lit.
Check that power is supplied.
If power is supplied and the status LED is still not lit, the probable cause is a software error.
Send charger for service.
Status LED on the charger is fixed red.
Send charger for service. Connect charger to PDM via USB and check if charger goes online. If
yes check software version of the charger.
Status LED is flashing red for 3s, then green
A factory reset has been performed. It may be necessary to set parameters from PDM/AIWS.
Status LED is flashing red (100 ms on, 800 ms off) for more than 3s
An error occurred during Easy Replacement. Remove portable from charger.
Status LED is flashing red (800 ms on, 100 ms off) for more than 3s
If the error occurred during Easy Replacement, remove the portable from the charger. The
charger should return to normal operation.
Otherwise send charger for service.
Charging does not start
Check that the telephone is properly inserted in the charger.
Advanced Charger does not appear in PDM/AIWS
Check that the communication cable (USB or Ethernet) is connected.
If charger doesn't appear in the AIWS device manager when connected via Ethernet you might
have to configure the AIWS IP-address with the PDM tool (refer to
appear in AIWS
Easy replacement does not start
Check that the handsets are of the same device type.
Check the handset software version. (refer to the configuration manual for details)
Check that the Advanced Charger software version is at least 1.3.7, see
page 276.
Avaya DECT R4 - Installation and Maintenance Guide
on page 274).
LED indications on page 278.
Advanced Charger
Advanced Charger does not
Software update
02/2016
on
687