Installation - Avaya DECT R4 Installation And Administration Manual

Installing Elise 2 Server (AIWS Hardware)
Troubleshooting information
●
Changing passwords
●
On the following occasions, the web page "xxx.xxx.xxx.xxx/system" must be used.
Current software installation has to be replaced.
●
No software is installed on Elise 2 Server (AIWS Hardware).
●
Compact Flash image update or installation
●
The system page can also be used when configuring network parameters.

Installation

Elise 2 Server (AIWS Hardware) should be placed in a dry environment with a temperature
range of 0 to +40°C.
The Elise 2 Server (AIWS Hardware) can be connected via system bus cabling, or via
twisted-pairs together with other units in the System 900. The Elise 2 Server (AIWS Hardware)s
can communicate with each other via the TCP/IP network.
!
Important:
The Elise 2 Server (AIWS Hardware) must be mounted in a vertical position to
Important:
ensure sufficient cooling for the electrical components.
!
Important:
Always follow the instructions in
Important:
(AIWS Hardware)
Server (AIWS Hardware).
Note:
Only install one Elise 2 Server (AIWS Hardware) at a time, otherwise problems
Note:
might occur during IP addressing.
Installation Procedure
1. Read chapters 4.1 and 4.2 before starting the installation.
2. At delivery Elise 2 Server (AIWS Hardware) is configured for system communication on
the A-bus. If modular system bus cabling is used and the B-bus shall be used for system
communication, follow the instructions in
3. At delivery, the Elise 2 Server (AIWS Hardware) is configured to be connected to a Central
Unit on the A/B-bus. If the Elise 2 Server (AIWS Hardware) should control the
communication on the A/B-bus, follow instructions in
controlling the communication on the A/B-bus
532
Avaya DECT R4 - Installation and Maintenance Guide
Powering down and restarting the Elise 2 Server
on page 527 when disconnecting the power to the Elise 2
Selection of A or B-bus on page 534.
Elise 2 Server (AIWS Hardware)
on page 535.
02/2016