Avaya DECT R4 Installation And Administration Manual page 200

Installing and operating the IPBS and IPBL
mod cmd RFP_UPDATE0 start /idle
Starts the update or activates the schedule. Normally the /idle command is selected and an
update starts only if the RFP is idle.
If multiple RFPs are selected for update, they will be updated one at a time If /sequence
command is used.
Example IPBS/IPBS2/IPBL
This example shows an "update file" for the IPBS, IPBS2, and the IPBL.
mod cmd UP0 prot http://172.20.8.128/Avaya/firmware/ ireset 5.0.0
mod cmd UP0 boot http://172.20.8.128/Avaya/boot/ ireset 5.0.0
Example Update RFP firmware
This example shows an update file for the IPBL.
mod cmd UP1 check ser 20070316 - 1
mod cmd RFP_UPDATE0 firmware http://172.20.8.125/avaya/rfp/Worf132.s2
mod cmd RFP_UPDATE0 select 0xxffff idle
mod cmd RFP_UPDATED start /idle
Configuration file backup
To make a backup of the configuration file, use the following command:
mod cmd UP0 scfg <url> [<final-command> <save-serial> [ /force
<hours>]]
The scfg command uploads the current configuration file to the specified <url>.
Example:
mod cmd UP0 scfg http://192.168.0.10/configs/saved/#h#b5.txt no-op
WEEKLY /force 168
The command above saves the device configuration file once a week with a backlog of 5
weeks.
To load a configuration file on the IP-DECT device use the following command:
mod cmd UP0 cfg <url> <final-command> <serial>
The command loads the configuration file, and all commands in it are executed.
Updating script for configuration of Kerberos clients
The update script is as follows:
200
Avaya DECT R4 - Installation and Maintenance Guide 02/2016