Configuring The Standby Master - Avaya DECT R4 Installation And Administration Manual

Configuring the Standby Master

Ensure that you have a Standby Master in the IP-DECT system. For more information, see the
corresponding subsection in
Note:
Make or change the configuration of the Standby Master only when the Master is
Note:
running.
1. Determine the address and access the GUI. See
2. Change the default password. See
3. Configure LDAP replicator, enter the IP address, user name and password to the LDAP
server. Alternative LDAP server must not be entered. Select the Enable check box. See
Configuring LDAP Replicator
4. Set a static IP address and set DHCP to off. See
5. Enter system name and password, this should be the same system name and password
as in the Master. See
6. Enter the Primary Master IP Address.
7. Set the mode to Standby Master. See
8. Configure the Master ID. See
9. Select PBX. See
10. Enter Master IP address. See
11. Select supplementary services. See
12. Assign PARI, see
13. Configure air synchronization. See
14. Enter AIWS IP address. See
management
15. Enter the Time Server address. See
16. Configure the LDAP replicator and enter the IP address, user name, and password to the
LDAP server. Write access is required for the Standby Master replication. New users in the
IP-DECT system must be created on the IPBS Master holding the database even if the
LDAP write is configured for the Standby Master. Do not enter the Alternative LDAP server.
Select the Enable check box. See
17. Enter the AIWS IP address. See
management
18. Reset in order to make the configuration changes take effect. See
If you cannot access the Standby Master from a certain PC after the reset;
Avaya DECT R4 - Installation and Maintenance Guide
Operation on page 115.
on page 147.
Changing the system name and password
Configuring Master ID
Configuring IP-PBX
Entering the IP address to the PARI Master
PARI on page 163.
Configuring air synchronization
Configuring messaging
on page 169 and Configuring the location
Configuring LDAP Replicator
Configuring messaging
on page 169 and Configuring the location
Accessing the GUI
Changing the default password
Setting a static IP address
Selecting Mode on page 154.
on page 155.
on page 155.
Configuring Supplementary Services
on page 169,
on page 169.
Configuring the NTP settings
on page 169,
on page 169.
Configuration
on page 96.
on page 99.
on page 141.
on page 149.
on page 162.
on page 153.
on page 164.
Device
on page 128.
on page 147.
Device
Reset on page 190.
109
02/2016