Updating The Software License - Avaya DECT R4 Installation And Administration Manual

5. Set section four in SW3 to OFF and press "Reboot" on the displayed web page, to leave
"Image installation mode".
6. Setup the parameters according to instructions in
page 545 or recover parameters from a backup file.

Updating the software license

1. Open the page xxx.xxx.xxx.xxx/admin and press "General".
2. Enter the new license, and press "Activate".
Circuit board replacement
Figure 185: Replacing the Elise 2 Server (AIWS Hardware) circuit board.
2
1. Perform a power down of the unit.
2. Remove the cover, see
3. Lift off the screw connectors from the circuit board. (1)
4. Press the four holding clips to release the circuit board (2).
5. Remove the circuit board (3).
6. Install the new circuit board in the case and make sure the circuit board clicks into position.
7. Set all switches and jumpers as they were on the original circuit board and replace the
screw connectors.
8. Check installation according to
Avaya DECT R4 - Installation and Maintenance Guide
2
2
3
1
2
Opening the housing
Installation test procedure
Maintenance information for the AIWS
Setup of network parameters
on page 533.
on page 546.
on
553
02/2016