Multiple Aiws Configuration - Avaya DECT R4 Installation And Administration Manual

Besides the software administration via the configuration page, it is also possible to administer
the software via the module's Boot Mode GUI. See
Boot Mode GUI is typically used if no software is installed on the module or if it is impossible to
access the software.

Multiple AIWS configuration

For some situations, there is a need to configure more than one AIWS in a system. This chapter
presents examples for multiple AIWS configuration. Examples of functionality distributed on
different AIWS's are Device Management, Central Phonebook and Netpage Messaging.
Functionality distributed on two AIWS modules
A system configuration with two AIWS's is required when there are more than 120 cordless
telephones simultaneously in the system, and Central Phonebook with LDAP/TFTP or NetPage
Advanced is used.
Figure 84: Example of a multiple AIWS solution with Device Handling on one AIWS and
DECT interface on another AIWS
Basic configuration for the setup
The basic configuration for this setup is described below.
AIWS A (Enterprise)
●
This setting is done in the Configuration page, not in the Setup Wizard.
- In Configuration > Other Settings > Advanced Configuration > Device
Management:
Replace the address 127.0.0.1/DECT with <IP address of AIWS B>/DECT,
that is, if AIWSB has the IP address 192.168.0.2, change to 192.168.0.2/DECT.
Avaya DECT R4 - Installation and Maintenance Guide
Installation and configuration
Installation of software on page 590. The
369
02/2016