Avaya DECT R4 Installation And Administration Manual page 176

Installing and operating the IPBS and IPBL
Moving RFPIs
In the Static Registrations section, initialized Radios no longer registered to the PARI Master are
shown. If it is vital that the new device keeps the RFPI for the broken device, move the RFPI for
the broken device to the new device registered to the PARI Master.
1. Connect the replacing device.
2. Add the Radio to the PARI Master, see
3. Select Device Overview > Radios
4. In the Static Registrations section, click Move for the Radio that is broken.
5. In the Move RFPI window, select in the Destination section the new Radio that you want to
move the broken Radio's RFPI to.
6. Click the Move button.
Existing RFPI on the new Radio is replaced by the broken Radio's RFPI. The new Radio's RFPI
is now released and can be reused. All other RFPIs in use are not affected. The broken Radio
will be deleted from the Static Registrations section.
RFPs
This section applies only to the IPBL.
Information about the DECT devices connected to the IPBL is available through RFPs.
1. Select Device Overview > RFPs.
2. Click the applicable port to open the RFP details pop-up window.
3. The following actions are available:
Click OK to save your settings and close the pop-up window.
●
Click Cancel to close the pop-up window.
●
176
Avaya DECT R4 - Installation and Maintenance Guide
Adding Radios on page 174.
02/2016