Install The Port Driver On Windows 7 - Avaya DECT R4 Installation And Administration Manual

Installing and operating the AIWS and the AIWS2
11. Click "Next". The installation of the port driver begins.
12. If a message opens, saying the software has not passed Windows Logo testing, click
"Continue Anyway".
13. Click "Finish". A dialogue box will open and inform you that new hardware is installed.

Install the Port Driver on Windows 7

Note:
When switching between mass storage mode and network mode, it takes about
Note:
30 seconds before the module can be accessed with the 192.5.36.229 address.
1. Connect a mini-USB type B cable between the USB port on your computer and the
management port on the module.
2. Press the Mode button twice to change the USB mode to mass storage. The module will
now turn up as a mass storage device on your computer. This is indicated by slow flashing
blue light on the Mode button LED.
3. Locate the required "elise3.inf" driver and save it on your computer.
4. Press the Mode button twice again to change the USB mode to network access.
5. Select Control Panel > Hardware and Sound.
6. Select "Device Manager" under Devices and Printers.
512
Avaya DECT R4 - Installation and Maintenance Guide 02/2016