General Information - Avaya DECT R4 Installation And Administration Manual

IC2
IC24
BAT1
LEDs
LED1
LED2-
LED5
LED6
LED7

General information

License
All Elise 2 Server (AIWS Hardware) units must have a valid software license.
The license can be found on the administration web page, under the section System
Setup > Common > License.
!
Important:
Changing this field may seriously affect the functionality.
Important:
If no valid license is present, the unit will not start and the Function Indicator (see
indicate license error with a slow flashing red light. The unit can be started in unlicensed mode,
see Unlicensed Mode
information. Unlicensed mode is indicated by the Function Indicator with an orange light (3000
ms ON/100 ms OFF), see also
Powering down and restarting the Elise 2 Server (AIWS Hardware)
Power Down
1. Remove the cover from the Elise 2 Server (AIWS Hardware).
2. Press the push button SW4 to perform a shut down of the processor.
3. Wait until the Function Indicator is flashing orange.
Avaya DECT R4 - Installation and Maintenance Guide
On-board flash memory (used for software reboot)
Module key
Backup battery
Function indicator with green, orange and red indication
Application dependent functionality. See documentation on the application for
description.
Communication on the Ethernet
Ethernet speed indicator. ON 100 MBit/s, OFF 10 MBit/s
on page 529 and
Function indicator
Selecting operating mode
on page 530.
General information
figure 170) will
on page 529 for more
02/2016
527