Avaya DECT R4 Installation And Administration Manual page 463

5. Select the device type to enable/disable login from
6. Change Status to desired value
7. Click Activate.
IP-DECT Base Stations
If your system having multiple Device Managers, it is possible to set which Device Manager the
IP-DECT base station (IPBS) should logon to. This can be used to logon the IPBS to one
Device Manager while another Device Manager for example can be used for handsets.
The IPBS can use either the Unite module's IP-address or the Service Discovery Domain ID to
logon to the wanted Device Manager. This chapter is only applicable when Service Discovery
Domain ID is to be used.
For example:
In the IPBS, the Service Discovery is enabled with Domain ID set to "UniteModule1", and the
Domain ID in your Unite module is also set to "UniteModule1". For more information see
Service discovery
in order to logon the IPBS to the Device Manager that matches the Domain ID.
1. Click Configuration on the start page.
2. Select Other Settings > Advanced Configuration on the Configuration page.
3. Under IP-DECT Interface, click Device Handling in the menu on the Advanced
Configuration page
4. In the Enable service discovery drop-down list, select Enable if the IP-DECT base station
uses service discovery to find the Device Manager.
5. Click Activate.
On-line status report time for chargers
You can configure how often a device type must "log in" in order to be considered on-line. This
is called "On-line Status Report Time". To enable moving a charger without being logged out, it
is possible to set a "Status Log Delay Time".
Avaya DECT R4 - Installation and Maintenance Guide
on page 465. In this case, enable the service discovery in your Unite module
Basic Configuration
463
02/2016