Avaya DECT R4 Installation And Administration Manual page 257

Since Communication Manager 4.0.3 and Communication Manager 5.1
The Location for Routing Incoming Calls parameter is only visible when SA9004 field is ON
and group type is H323. The setting for Location Routing Inc Calls provides the location from
where the call is being initiated over the Signaling Group. If "Location Routing Inc Calls" field of
Signaling Group is blank (default value), the location of CLAN's cabinet or the location of the
Processor Ethernet (PE) is taken for routing the call, depending on whether CLAN or PE is
being used to carry that H.323 signaling channel.
.
Page 1 of
Group Number: 110
IP Video? n
Trunk Group for Channel Selection: 110
TSC Supplementary Service Protocol: a
T303 Timer(sec): 10
H.245 DTMF Signal Tone Duration(msec):
Near-end Node Name: aled-S85_CLAN_1
Near-end Listen Port: 5210
LRQ Required? n
RRQ Required? n
Media Encryption? n
DTMF over IP:
Link Loss Delay Timer(sec): 90
Enable Layer 3 Test? y
Avaya DECT R4 - Installation and Maintenance Guide
5
SIGNALING GROUP
Group Type: h.323
Remote Office? n
In-band
Communication Manager system administration
Max number of NCA TSC: 5
Max number of CA TSC: 5
SBS? n
Trunk Group for NCA TSC: 110
X-Mobility/Wireless Type: DECT
Location Routing Inc Calls? xxx
Far-end Node Name: Master IPBS
Far-end Listen Port: 5210
Far-end Network Region: 1
Calls Share IP Signaling Connection? n
Bypass If IP Threshold Exceeded? n
H.235 Annex H Required? n
Direct IP-IP Audio Connections? y
Interworking Message: PROGress
DCP/Analog Bearer Capability: 3.1kHz
IP Audio Hairpinning? n
02/2016
257