Operating Modes - Avaya DECT R4 Installation And Administration Manual

Installing Elise 2 Server (AIWS Hardware)
4. Remove the power cable. The power must be removed within 10 minutes or Elise 2 Server
(AIWS Hardware) will restart. If Elise 2 Server (AIWS Hardware) restarts, wait until the
Function Indicator is not indicating starting up (flashing orange) before pressing SW4
again.
Restart
There are two ways to restart an Elise 2 Server (AIWS Hardware):
following the power down instruction above, and then apply the power again, or
●
initiate a restart from the administration web page.
●

Operating Modes

There are five different operating modes; normal, network setup, fail-safe, image installation
and unlicensed.
Network Setup Mode
To be able to contact the Elise 2 Server (AIWS Hardware), a valid and unique IP address is
necessary. In this mode, the IP address is set to 192.5.36.229, which is reserved for installation
of Elise 2 Server (AIWS Hardware). Network Setup Mode should only be used when Elise 2
Server (AIWS Hardware) has not got any IP address or when the IP address has to be
changed, i.e. if Elise 2 Server (AIWS Hardware) has been moved from one network to another.
Fail-safe Mode
This mode can be used when it is impossible to contact the Elise 2 Server (AIWS Hardware).
When started in Fail-safe Mode, no applications are started. It is possible to return to factory
settings or a backup copy of parameters from the web page xxx.xxx.xxx.xxx/admin
(xxx.xxx.xxx.xxx is the IP address given to the Elise 2 Server (AIWS Hardware)). If there is a
problem accessing this page, it is possible to access xxx.xxx.xxx.xxx/system, where it is
possible to change network parameters or install new software.
Image Installation Mode
The Compact Flash includes the Elise 2 Server (AIWS Hardware) operating system and
application software. If all information (operating system and application software) needs to be
updated, then the complete Compact Flash image must to be replaced. The Elise 2 Server
(AIWS Hardware) is normally set in image installation mode from the administration pages but it
can also be set by the operating mode switch. See
Flash on page 551 or
If the Compact Flash needs to be partly updated with new application software, the image
installation mode should not be used. For more information, see
software on page 550.
528
Avaya DECT R4 - Installation and Maintenance Guide
Installing an image on an empty Compact Flash
Replacing an image on the Compact
on page 552.
Updating application
02/2016