Avaya DECT R4 Installation And Administration Manual page 97

Note:
If the GUI cannot be accessed with Internet Explorer 8 or newer, check that the
Note:
TLS 1.0 option is activated in the web browser under menu Tools > Internet
Option > Advanced > Use TLS 1.0.
Determining the IP address
The factory setting of the DHCP mode for the LAN port is automatic. At first power up, the
IPBS/IPBL acts as a DHCP client. If the network has a DHCP server, the DHCP server assigns
an IP address to the IPBS/IPBL. If the network does not include a DHCP server, the IPBS/IPBL
can be assigned a predefined IP address.
Note:
After the first startup, change the DHCP mode from automatic to either client or
Note:
off, see
Use the IP address to reach IPBS through a Web browser. To determine the dynamically
allocated IP address, you can use one of the following methods:
In a network without a DHCP Server
●
In a network with a DHCP Server
●
In a network without a DHCP Server
To determine the IP address in a network that does not have a DHCP server and the DHCP
mode is set to automatic, that is the factory default use the following procedure:
Note:
If you have used the IPBS/IPBL before, restore the IPBS/IPBL to factory default
Note:
settings by performing a long hardware reset, see
page 191.
1. Connect the IPBS/IPBL and the computer with a ethernet cable.
Note:
Use a power adapter for IPBS. For IPBL, use the LAN1 port.
Note:
2. Ensure that the computer has an IP address in the range of 192.168.0.2 to 192.168.0.254
This range is the same range as the IPBS/IPBL.
3. Perform a hardware reset by pressing the reset button. The IPBS/IPBL is then assigned
the IP address 192.168.0.1 and the netmask 255.255.255.0.
4. Enter http://192.168.0.1
5. After the first startup:
On the IPBS: Select LAN > DHCP
●
On the IPBL: Select LAN1 > DHCP
●
Avaya DECT R4 - Installation and Maintenance Guide
Setting DHCP mode on page 140.
in the browser address field to access the IPBS/IPBL GUI.
on page 97.
on page 98.
Reset using the reset button
Configuration
on
97
02/2016