Avaya DECT R4 Installation And Administration Manual page 306

Installing and operating the Rackmount Charger
Figure 77: The mains power supply connection
8. Mount the safety cover and fasten it with one screw.
9. Secure the mains power supply cable with two screws (2), which are provided in the parts
bag, see
10. Replace the top cover, see
11. Fasten the power cord to the wall depending on local regulations.
12. If more rack chargers shall be connected, repeat the above steps 1-12 for the next unit.
Installation test
1. When the fixed installation is completed, apply ,AC power by switching on the disconnect
device.
2. The LED on the front of each charger shall now light up.
Communication cable connection
The communication cable connections are situated under the top cover of the Rackmount
Charger.
Figure 78: Communication connections inside the Rackmount Charger
Ethernet connections
When connecting several Rackmount Chargers over Ethernet, it is possible to connect them in
series using the two Ethernet connections. Power over Ethernet is not supported.
306
Avaya DECT R4 - Installation and Maintenance Guide
figure 76.
figure
USB connection
74.
02/2016