Cordless Extension Number Test - Avaya DECT R4 Installation And Administration Manual

Installing and operating the IPBS and IPBL
4. One user of the cordless telephone should now start moving around the covered area.
Both users must check that a good speech quality is maintained everywhere. Special
attention should be paid to areas such as edges of the building and areas behind metal
structures where there is a possibility of reduced speech quality.
5. Check signal strength should be better than -68 dBm, speech will get affected at about
-75dBm.
6. Mark areas where cracking sounds or mutes are heard.
Evaluation
After having performed the coverage area test, the results should be evaluated. If the coverage
is not sufficient you should review the planning and move or add equipment.

Cordless extension number test

This test checks for each cordless phone the complete connection from the IP-DECT system to
the PBX. Furthermore it checks that the cordless phones' numbers have been correctly
programmed. The test is performed by calling all cordless phone from one specific cordless
phone.
1. Put all cordless phone together in order of extension number on a table.
2. Go off-hook with each cordless phone and check that the dial tone is heard.
3. Call with a cordless phone (cordless phone A) all other cordless phones sequentially and
check that the cordless phone with the corresponding number on its display rings when
called.
4. Call cordless phone A and check if it rings.
194
Avaya DECT R4 - Installation and Maintenance Guide 02/2016